| BABY BORDER DESIGN Designed for you by SHARON MURPHY Crafts1@ibm.net Supplies Needed: Note: If you prefer, use a hand cut diaper made to fit the baby die cut. This needs to be made before mounting your baby die cut. See directions below on how to make the diaper.) |
|
|
1.) If you would like to add a diaper to your Baby die cut, these are the steps I used to make mine. I held the die cut up to the window and placed a small white piece of cardstock of it. I then drew a diaper on the white cardstock. Cut out your diaper and make sure that it fits the baby die cut the way you like. Then add little dashed lines around the outside of the diaper. Then add little "x"s on the diaper for design. It is ready to glue onto your baby die cut. 2.) Take your 12 x 12 white cardstock and draw a wavy line with the wavy border ruler down the right (or the left) side of your page. Approximately 1 inch from edge. Flip the ruler over and place on top of the line you just drew. Line the ruler so that it looks like ovals all the same size down your page. Draw your line. 3.) Draw little stars down each the left and the right side where your lines cross. 4.) Place the Baby die cut at the bottom corner with its feet over the drawn lines facing in toward your page. 5.) Next, take the 4 baby bottle die cuts and place them about two inches apart on the drawn wavy lines. Alternating the direction of the bottle. 6.) Your page is now ready for pictures and journaling.
|
||
